Roofing & Storm Damage Repair pricing in Houston
Roofing costs in the Houston area are driven mainly by roof size (measured in "squares," or 100-square-foot sections), material choice, roof pitch/accessibility, and whether storm damage is involved. Use the ranges below as a starting point for budgeting; every roof is different, so the only way to get an exact number is a free on-site inspection and written quote.
Estimated cost by service
| Service | Typical Cost | Notes |
|---|---|---|
| Roof Inspection | $0–$300 | Many Houston roofers offer free inspections, especially after storms; detailed drone or attic inspections may run higher. |
| Roof Leak Repair | $350–$1,500 | Price depends on how many leak points and how hard they are to trace. |
| Emergency Roof Tarping | $300–$1,200 | After-hours or storm-surge pricing may apply during active severe weather. |
| Shingle Roof Repair (spot repair) | $400–$1,800 | Covers a small section of missing or damaged shingles. |
| Asphalt Shingle Installation (full roof) | $8,000–$16,000 | Based on a typical 2,000–2,500 sq ft Houston single-story home. |
| Architectural Shingle Upgrade | $10,000–$20,000 | Thicker, more wind-resistant shingles than standard three-tab. |
| Flat Roof Repair | $400–$2,000 | Seam failures and ponding water repairs on low-slope sections. |
| TPO Roofing Installation | $6,500–$14,000 | Priced per square for a typical low-slope residential or commercial addition. |
| Modified Bitumen Roof Installation | $5,500–$12,500 | Common on garage additions and low-slope porches. |
| Metal Roof Installation | $14,000–$35,000 | Standing-seam and higher-end panel systems cost more than exposed-fastener metal. |
| Metal Roof Repair | $400–$2,500 | Fastener replacement, seam resealing, or panel section swaps. |
| Tile Roof Installation | $18,000–$45,000 | Clay and concrete tile are heavier and more labor-intensive to install than shingles. |
| Tile Roof Repair | $400–$2,000 | Cracked or slipped tile replacement; matching older tile profiles can add cost. |
| Hail Damage Roof Repair | $500–$4,000 | Cost varies widely with hail size and how much of the roof was affected; often covered by insurance. |
| Wind Damage Roof Repair | $500–$5,000 | Lifted or torn shingle sections after Gulf storms and tropical systems. |
| Full Roof Replacement (insurance/storm claim) | $8,000–$25,000 | Actual out-of-pocket cost often limited to your deductible when a claim is approved. |
| Roof Ventilation Installation | $300–$1,200 | Per vent installed, such as box vents or turbine vents. |
| Ridge Vent Installation | $500–$1,800 | Runs the length of the ridge line; priced per linear foot. |
| Skylight Repair | $250–$1,200 | Reseal or reflash an existing skylight leak. |
| Skylight Installation (new) | $1,500–$4,500 | Includes cutting the roof opening, flashing, and interior finish work. |
| Chimney Flashing Repair | $350–$1,500 | One of the most common sources of hidden leaks around masonry chimneys. |
| Roof Flashing Repair (valleys, walls, vents) | $300–$1,500 | Priced per flashing area addressed. |
| Soffit and Fascia Repair | $500–$2,500 | Per linear foot pricing; full perimeter replacement costs more. |
| Gutter Installation | $1,500–$4,500 | Seamless aluminum gutters for an average Houston single-story home. |
| Gutter Guard Installation | $1,200–$4,000 | Mesh or micro-mesh guards added to existing or new gutters. |
| Gutter Cleaning | $150–$400 | Typical single-visit cleaning for an average-size home. |
| Roof Coating (elastomeric) | $1,500–$5,500 | Common on flat and low-slope sections to extend roof life and reduce heat. |
| Roof Decking Replacement | $70–$150 | Per sheet of plywood decking replaced, in addition to shingle/material costs. |
| Attic Insulation Installation | $1,500–$4,500 | Blown-in or batt insulation added or topped up during a roof project. |
| Commercial Roofing (per square foot) | $4–$12 | Wide range depending on system type (TPO, EPDM, metal) and roof condition. |
Cost comparisons
Repair vs. Replacement
A rough guide to when a repair makes sense versus a full replacement.
| Option | Typical Cost | Best For |
|---|---|---|
| Minor Repair | $350–$1,800 | Isolated leaks, a few missing shingles, or damage under 10% of the roof |
| Major Repair | $1,800–$5,000 | Multiple problem areas or storm damage affecting a large section |
| Full Replacement | $8,000–$25,000 | Roofs 20+ years old, widespread storm damage, or repeated recurring leaks |
Full Roof Replacement Cost by Size
Estimated installed cost for a standard asphalt shingle roof; larger or steeper roofs run higher.
| Roof Size | Approx. Squares | Typical Cost |
|---|---|---|
| 1,200–1,500 sq ft | 12–15 squares | $5,500–$10,000 |
| 1,600–2,000 sq ft | 16–20 squares | $7,500–$13,500 |
| 2,100–2,500 sq ft | 21–25 squares | $8,500–$16,500 |
| 2,600–3,200 sq ft | 26–32 squares | $10,500–$21,000 |
| 3,300+ sq ft | 33+ squares | $13,000–$28,000+ |
Roofing Material Cost Comparison
Installed cost per square (100 sq ft) including labor; varies by product tier and roof complexity.
| Material | Cost per Square | Expected Lifespan |
|---|---|---|
| 3-Tab Asphalt Shingle | $350–$550 | 15–20 years |
| Architectural Asphalt Shingle | $450–$750 | 25–30 years |
| Metal (Standing Seam) | $900–$1,800 | 40–60 years |
| Metal (Exposed Fastener) | $550–$900 | 30–45 years |
| Clay/Concrete Tile | $900–$2,200 | 50+ years |
| TPO / Flat Roof Membrane | $450–$800 | 20–25 years |
What affects the price
- Roof size and pitch: steeper roofs require more safety equipment and labor time, raising the price per square.
- Material choice: architectural shingles, metal, and tile cost significantly more upfront than basic three-tab shingles.
- Number of layers to remove: tearing off an existing roof (or multiple layers) adds labor and disposal costs.
- Extent of storm or hail damage: partial repairs cost less than replacing large sections or the entire roof deck.
- Roof accessibility: steep slopes, multiple stories, or limited yard access can increase equipment and labor needs.
- Decking condition: rotted or water-damaged plywood found during tear-off adds material and labor cost per sheet.
- Permit and code requirements: some Houston-area municipalities require permits and specific wind-rated materials.
- Insurance involvement: storm-related claims can shift much of the cost to your deductible rather than out-of-pocket payment.
Example projects & pricing
Example: Small Leak Repair After a Summer Storm
A single traced leak around a roof penetration on a typical Houston home, repaired with new flashing and sealant.
Example: Full Asphalt Shingle Replacement, 2,000 sq ft Home
Tear-off of one layer of aging three-tab shingles and installation of new architectural shingles, underlayment, and ridge vent.
Example: Hail Damage Claim, Moderate Damage
Insurance-approved full roof replacement where the homeowner pays only their policy deductible; total job value may exceed $12,000.
Example: Metal Roof Installation, 2,500 sq ft Home
Standing-seam metal roof chosen for storm durability and longevity, including tear-off of the existing shingle roof.
Pricing FAQs
How much does a new roof cost in Houston, TX?
Will my homeowners insurance cover roof storm damage?
How much does it cost to repair a roof leak?
Is it cheaper to repair or replace my roof?
These are estimated ranges for the Houston, TX area for informational purposes only; actual pricing varies by job. Request a free quote for an accurate price.